Bicycle V Brake Tension Spring

If you tighten the spring on the left that pad will pull further away from the rim while the right pad moves.

Bicycle v brake tension spring. Now re install the brake pads with the washers in the same order as they were before. To adjust the brakes on your bike start by checking your brake pads which are the pads that clamp down on the front tire of your bike when you pull the brake lever. They should hit the center of the rim with an equal amount of space above and below them. Generally the hole which provides more tension should be used with a narrower rim.

Install align brake pads. Most direct pull cantilevers have a fine adjustment for spring tension. Make sure that both brake arms use matching holes. There are spring tensioner screws on both brake arms so you ll need to adjust both incrementally until you find the right balance.

V brake pads are different from traditional pads in that they don. Align the brake pads so the pad face is flat against the rim. Some brake bosses have more than one hole for the end of the spring to allow a rough adumstment of spring tension. Any changes you make to the tension on one side will have a direct effect on the other side.

Spring adjustment if your wheels are centered and your brakes are not and if the pivots are properly lubricated and free moving the brake shoes should be centered. If they are not you probably need to adjust the spring tension on one or both of the cantilevers. Then tighten the mounting bolt. V brake adjustment part 3 spring tension bikemanforu repair duration.